The Cessna 210 was never certified to spin

The ATSB found an instructor likely spun a Cessna 210N never approved for intentional spinning. Certification is the margin a mishandled stall depends on.

The ATSB has found it likely that a flight instructor put a Cessna 210N into a spin so the pilot in the left seat could practise the recovery. The aircraft was never approved for intentional spinning. The three people on board died when it struck the water near the Murray Mouth, south of Adelaide, on 6 February 2026.

The certification is the margin
Cessna built the 210N as a Normal category aircraft, which the US civil air regulations it was certified under define as non-acrobatic. The spin test in that standard, CAR 3.124, required recovery from a one-turn spin within one more turn, and a placard against spins. The test gives a pilot a margin when a stall is mishandled. What the aircraft does in a fully developed spin was never established.

Cessna told the ATSB: “At no time did we ever intend to certify the 210N model as an aircraft approved for intentional spins.”

The prohibition sits in the limitations and emergency sections of the pilot operating handbook, with the procedure for an inadvertent spin beside it. The placard against spins was not on the instrument panel.

Seven flights before this one
The ATSB found seven earlier flights where the instructor started a spin. Entries began at about 4,500 ft in December 2025, about 3,500 ft in January, and about 3,000 ft a week before the accident. One recovered at 1,952 ft, below the 4,000 ft recovery height Cessna recommends for the aircraft it does approve for spinning. Every one came out, and the ATSB says that record gave the instructor confidence to keep lowering the entry height.

On the accident flight the aircraft climbed to about 3,375 ft and slowed to 74 kt, consistent with a spin entry. A witness on the western side of the Murray Mouth filmed the last seconds: a left turn spin, nose down about 72°, 218° of rotation while losing 292 ft in 1.7 seconds. The rotation slowed as it neared the water, so the aircraft was answering recovery inputs. There was not enough height for the answer to arrive. The ATSB judges the spin would likely have been recovered at the height used two months earlier.

The pilot had about 199 hours, nearly all of them in Diamond DA40s and DA42s, which are not aerobatic, so spin recovery was never part of his training. The instructor gave no ground brief on spins; the subject came up after they were airborne, in a short explanation of the PARE recovery sequence. The ATSB found it unlikely the pilot understood how a recovery in a 210N could go wrong.

Not reported to the operator or CASA
None of the pilots who flew those spins told the operator or CASA. The ATSB recorded why: trust that it must have been allowed, deference to the instructor's experience, a wish not to cause trouble, disbelief, and a belief that it was not their job. A report could have been checked against recorded data. Either the operator or CASA could then have stopped it.

If someone offers you a spin
CASA's advisory circular on spin avoidance and stall recovery training lists the rule first: “A spin must not be induced in aircraft not certified or approved for intentional spinning”.

Approval comes with narrower limits than most pilots expect. The Cessna 172R this operator used for line training allows spins in the utility category only, with the rear seat empty, and the ATSB found a flight where a pilot sat in the back. Spin training is normally flown high enough to recover by 3,000 ft above ground, and this instructor's aerobatics height limit had been lowered to 1,500 ft in November 2025.

The limitation is printed in the flight manual of the aircraft you are boarding. Check it yourself. When the answer is no, it does not matter how many times the person in the right seat has got away with it.